Topics created by c.man

@Martin-Kudláček I now use the Lunatone 0-10V dali controler 886468352-HS (30ma). This is working very fine on the 1-10V analog output on my M203's. We now have two units running in the field. I now can control the dali system with my hmi screen. Again thnx for the support. Best regards, John-paul

@c.man It should work.
The UniPi board is adding drivers to the existing Raspberry Pi UART signals.
CODESYS for UniPi doesn't add anything to support the serial ports.
CODESYS for Raspberry Pi supports the raspberry Pi serial ports and Modbus, including the ASCII mode.
If you require further assistance on the software side of this I suggest that you use the CODESYS raspberry Pi Forum.
If you have signalling issues then I'm sure UniPi can assist you.

I hope that helps

@c.man I have not seen one but basically, you need a 5V USB battery which will be able to charge and be charged at the same time

@c.man The codesys package for Unipi is working well. But you will need to figure out the way how to communicate between codesys and OpenHAB. And for that, I would recommend using Mobus TCP - create a TCP Modbus server in Codesys, map the variables you want to have available in OpenHAB to the Modbus registers and read/write to/from them in OpenHAB... Or you already have that solved?

@tomas_hora When do you expect to release the firmware required to make Neuron operational with @DavidCozens codesys port?

We are all waiting not so patiently.

Thanks