Posts made by Meethos

Dear All Users,

Do you have any experience to bring signal comming about lower electricity rate (in czech republic HDO) into Neuron ? I want to bring information into Mervis program, when it can activate heaters in low rates.

Thank you.

Dear All,

Has anybody experience with installing Node red into Neuron ? Is possible use DI and 1Wire sensors as input into Node red and DO, RO etc. as output in it ?

I want to catch MQTT messages (from different devices) and use it as input for Neuron action (simple - Nanopi will get signal on DI, generate MQTT message, send it via network to Neuron and Neuron switch on relay).

For any experience I will be happy. I will try to do it by myself and if I will have any succes, I will give information there.

Thank you

Hello,

I am trying to configure 1wire temp sensors on L203, but I still have problems. Could you please help me to add 1Wire channel in Mervis for L203 ? I try to use tutorial from YT - create 1W channel, add sensor, set commision mode and than assigne 1W sensor. Till there all is OK. But if i sync this configuration and start debuging mode, there are no values from sensors. Also I can not see 1W sensor as variable in program design.

Any idea, what i did wrong ?

Thank you.