Posts made by domguard

Hello
I have a L203 that is managing the house hot water and heat/air system
The power supply died, but seems to have damaged something
I thought it was the SD card corrupted, but even after a fsck, and trying another SD card with a fresh new image brings the same symptoms :

All digital inputs and outputs lights are lit (fixed) and RUN2 and RUN3 leds are flashing together.
The ethernet plug does not seems to be active on the ethernet hub

Can I have a diagnostic ? I have to repair this quickly as my thermo-solar panels are managed by this unit.
Thank you for your help

Hi @roberts_lando, I have the exact same case , an inverter with three pins (+/-/GND) , did you found any solution ? I have a Neuron, it has also only two pins.
But it has a "END" switch next to the RS485 connector
thanks

Having the Unipi as an access point would simplify my last project
When using installed image or apt with EVOK, the systemd services seems not to be installed.
So I tried the 2.4.30 legacy script install, changing the NO_WIFI=true parameter to false, it sort of worked, I had to install hostapd by myself but ended with an hostapd error : Failed to start Advanced IEEE 802.11 AP and IEEE 802.1X/WPA/WPA2/EAP Authenticator.
The SSID was visible but I could not connect to it.

Is there a way to easily use this Evok/Unipi feature ot let's say it's dead ?

thank you very much