Topics created by Stoeffel

@cleve
Hello Cleve

Thanks for reply.

sudo apt-get -o Dpkg::Options::="--force-confmiss" install --reinstall evok-unipi-data

Did what it was supposed to do.
Thank a lot for your help.

Hello Thomas

Exemple with L503, xS51 and xG18. I also have some
DS18B20 on the 1Wire Bus.
Install Steps:

Check if everything is configured and works correct in evok Check output of <IP_of_Neuron>/rest/all in your Browser Install FHEM from the repository (https://fhem.de/#Installation) Connect FHEM with your Neuron by typing: define <Name> Neuron <IP>:80 set attributes like in the picture (see on the bottom) below

33af1b3e-7f12-4e72-9537-d3295fc93b6e-image.png

After that all inputs and outputs get recogniced automatically.
You will get a room named NeuronPin with all devices.

Example (with some changed names):
b4430f01-8ff0-46ad-bb4c-e75254958745-image.png

Example of a analog input with a PT1000 Sensor for Temp. mesurment:
46c55b40-b0fc-4e6c-bfc9-23234f3aea3d-image.png

Example of a analog input with a Honywell PX3 pressure sensor:
d38edfa9-8b54-40af-a144-2569bbdb9b9b-image.png

I am developing a control system with FHEM for my distillery with a heat recoupling for the building heating of the residential house. When I'm finished, I'll be glad to present the project to you.

As promised, here is the feedback.
The problem has definitely been solved.
Many thanks for the help

Kind regards
Stefan

So. Now I solved the problem:
After a

sudo apt-get remove --purge evok && sudo apt-get update && sudo apt-get upgrade && sudo apt-get install evok

and with this new configuration in the evok.conf I got it:

[EXTENSION_1] global_id = 2 ; Mandatory, REQUIRED TO BE UNIQUE device_name = xG18 ; Mandatory modbus_uart_port = /dev/extcomm/0/0 ; Mandatory ;neuron_uart_circuit = 1_01 ; Optional allow_register_access = True ; Optional address = 1 ; Optional, scan_frequency = 10 ; Optional, scan_enabled = True ; Optional, ;baud_rate = 19200 ; Optional ;parity = N ; Optional, ;stop_bits = 1 ; Optional