Posts made by zorro_66

Ok thanks for the answer.
How many sensors can a Unipi light handle.
I have connected 15 sensors now and the 1-wire bus stops after about 5 hours and requires a reset to work again.

I use a Unipi light and would like to use the function automatic reset 1-wire bus where do I find the variable OW_off_1.
The manual for this function is very poor

ok they're just as good then I'll get further troubleshooting
no i know ssl is not working that's why i have a separate relay server

I have set up my own smtp server for alarm handling by mail
It works perfectly with my Unipi but I it´s not working with my Unipi light, it's not possible to send mail with a light ver.
It does not seem to be in touch with the smtp server.
I'm using Mervis.

So how do I do to send mail?

How should I do to send mail from Unipi 1.1
There is no way to enter Authentication TLS
all mail systems require it.
Or have I missed something

Ok tanks

I can not change the time, I receive the following error message
Unipi light with latest Mervis
Error PLC 0 1 Failed to set controller time(WriteFailed).

Yes embarrassing.
Now it has happened to me too
thanks for the help
now it works

Yes it is used to delay alarm mail

I am using latest Mervis and a Unipi Light with the latest firmware
but get a problem see picture.
Anyone who has a solution

Page 26 of the manual

Set the PLC to Commissioning mode –Right click on the PLC icon in Solution Explorer and choose PLC Operation→ Commissioning mode

I have the same problem and have not managed to solve it.
Here is the answer I received in a previous thread

https://forum.unipi.technology/topic/337/mervis-hmi

Thanks for the quick reply Tomas
Well, I know I had nothing connected to that block but did not think it was the fault.
Because it's on the position my time_Converter was supposed to enter.
Which two programs have I mapped that are not available

Hello
Tomas, you've probably got a link to Dropbox and my project
Sorry it took some time to fix but i have been on vacation

How can I send the project to you i tried to mail but it did not work.
I can not upload this one has no privileges so it's enough

Indicates that it is wrong in any column
But the error changes depending on where I have the cursor standing

I have tried to do the function block
But i just get "build fail."
Do I have to write any more parameter in the block or matter it works directly

FUNCTION_BLOCK IntlToSec
	VAR_INPUT
		seconds_int: int;
	END_VAR
	VAR_OUTPUT
		out_time : TIME;
	END_VAR

out_time := mul_time(time#1s, seconds_int);
END_FUNCTION_BLOCK

:smiley:

I want to control the time of my timer block with HMI

How do I want to use SET

If I enter the value 20 in the SET box, it will be 21 hours and 21 minutes.
I only want to use minutes

Thankful for help or a kick in the right direction